eTraxx.com
 
 
 
 350Z » Exterior » DIY
Exterior - Do it Yourself
DIY. Do it Yourself. Theoretically then a DIY is something that you don't have to pay someone elese to do. I suppose that is relative to your time, ability and inclination. :) Feedback
Admin Note: eTraxx.com recommends that you seek advice from a qualified vehicle technician before carrying out any repairs or modifications on a vehicle following advice given on the site. eTraxx.com will not be held responsible for any damage caused by following incorrect advice given; you do so at your own risk.
 
Lighting Dismantle Other
PDF File 06 LED Taillight install
06 LED Taillight Install: The hottest tail light upgrade currently selling for 03-05 350Z's are these LED based 2006 350Z tail lights. They are significantly brighter than the earlier tail lights, in addition to being a great new look. They are direct replacements for the stock 03-05 units (Note possible exception for Australian spec 03's)
PDF File LED Markers (strip LEDs)
LED Sidemarkers: Lighting your Sidemarkers: LED Blinkers & Parking Lights You will need to do is purchase the 12 light LED strip. You only need to order one strip. You will separate this strip into two separate pieces. These LED strips are actually designed to separate in this manner. What works well together are clear LEDs if you have the Amber reflectors and Amber if have clear reflectors.
PDF File LED Corner Reflectors (Single LEDs)
DIY LED Corner Reflectors: Using single LEDs purchased from Superbrightleds.com, this DIY uses three LED's and a matching resistor and built a small array which is wrapped in heat shrink and electrical tape.
PDF File LED Clear Marker Install
LED Clear Corner Install: This write-up covers installation of LED clear corners but is written with intent to assist you with any of the following things on your 350Z: Installing clear corners or LED clear corners, Front bumper removal for any reason, Splash guard removal (replacing bulbs etc.)
Taking apart the exterior
PDF File Remove Bumper
Front Bumper Removal: This write-up covers installation of LED clear corners but is written with intent to assist you with any of the following things on your 350Z: Installing clear corners or LED clear corners, Front bumper removal for any reason, Splash guard removal (replacing bulbs etc.)
Anything not covered in a specific area
eTraxx.com webpage Greddy lip with widened grille
Bumper: An attempt to go from a Photochop to reality.
PDF File S-O-R Cobra chrome fuel door
Chrome Fuel Door: The German company S-O-R Cobra offers a chrome plated stainess fuel door. This link is to the instalation PDF. Could be useful for those wanting to mod thier fuel doors themselves.
Website Ramps for slammed cars
Ramps for lowered cars: This DIY for is from the Mustangword.com website and was written for 'slammed stangs and the DIY'er'. To quote= "If your stang is lowered more than 2 inches, or you just find it a PITA to lift the front of your car then you might need to make yourself some MW ramps." - is another option for 'slammed Z's'
 
Comments       Add Comments
© 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008 eTraxx.com